无锡亚博兰机械设备有限公司
Wuxi Ybolan Machinery & Equipment CO.,LTD
Home > Knowledge > Content
Aluminum Curtain wall processing specific types and forms of processing
Jan 26, 2018

Aluminum curtain wall processing, the simple understanding is the processing of aluminum alloy curtain wall, then, for this kind of processing, may wish to be familiar with and understand, in order to grasp the relevant knowledge and know how to proceed correctly, so as to ensure a good Processing effect.

 

1. The processing of aluminum curtain wall panels

As aluminum curtain wall panels belong to the aluminum curtain wall, so, it is also within the scope of aluminum curtain wall processing.

Its processing steps or steps are: cut off the aluminum plate - vulcanization - electrostatic spraying - hot bake - hot molding.

Its processing costs, can be used in building wall decoration.

 

2. What is aluminum veneer curtain wall and its material and specific types

Aluminum veneer curtain wall is made of high strength aluminum alloy sheet processed.So, its material is aluminum alloy.In thickness, there are generally 1.5, 2, 2.5 and 3 of these four specifications, the unit is mm.In composition, is the panel, ribs and angle code of these three.

In summary, this kind of curtain wall processing, but also in the context of aluminum curtain wall processing.

 

In addition, aluminum veneer curtain wall in two specific types of veneer,

One is the thickness of 1.2mm below, called the aluminum buckle or aluminum square plate.Another is the thickness of 1.5mm above, called aluminum veneer or aluminum curtain wall.

 

3. Aluminum curtain wall processing is there a variety of forms?

Aluminum curtain wall processing in terms of specific, mainly  the following two.

Composite aluminum: aluminum alloy that is combined with other materials, is the site can be processed, so that the building can be a good solution to dimensional changes caused by errors.

Aluminum veneer: is an aluminum curtain wall, usually produced by the manufacturer, and then shipped to the installation site. Therefore, the secondary design requirements, is relatively high.

http://www.alucncmachining.com/