无锡亚博兰机械设备有限公司
Wuxi Ybolan Machinery & Equipment CO.,LTD
Home > Knowledge > Content
Solar frame processing and production operations precautions
Dec 23, 2017

In the actual production process, the entire production process of Solar frame processing is very strict, and therefore must pay more attention to the operation process. First of all, we should properly complete the pouring of aluminum rods. In other words, in the process of casting, should control the content of different elements, be sure to ensure that the Solar frame processing aluminum purity.

 

At the same time, during the processing of solar energy frame, after the completion of oxidation and sealing operations, there should be no material mixed in order to prevent the extrusion process, the surface black spots and burrs or graining, which will affect the profile The surface quality. The second is to pay attention to the mold polishing requirements. Under normal circumstances, during the polishing process, be sure to ensure that all burrs on the mold clean.

 

During the process of polishing the solar frame, pay attention to the reasonable control of the quality of its different surfaces, as far as possible to avoid extrusion scars or marks. Next, control of the temperature of the mold, the temperature of the aluminum rod, and the extrusion speed should be taken into consideration during the extrusion operation. Remember, for any one mold need to be tested for the first material and the end material, shall not miss seized.

 

It should be noted that, in this process, if you find unusual problems, then be sure to promptly stop squeezing to replace the mold and then crowded. Be sure to use solar panel processing of high temperature felt blank material, when cutting the excess pressure should pay attention to not have debris into the surface to prevent black spots or burrs. At the same time also pay attention to grasp the cooling of the discharge port.

 

Under normal circumstances, after the cooling process, but also need to complete the processing of solar frame straightening requirements. Be careful, straightening too small will have a big bend in the sawing blank can not be too much, while taking care of the material and the material to set aside the appropriate gap. Solar frame processing process should pay attention to reasonable control of the furnace temperature, the furnace must be measured when the two ends of the hardness.

http://www.alucncmachining.com/