无锡亚博兰机械设备有限公司
Wuxi Ybolan Machinery & Equipment CO.,LTD
Home > Knowledge > Content
Steel processing equipment processing and use advantages
May 09, 2018

In the process of operation, the steel processing equipment compactor mainly presses the low-carbon steel, stainless steel, copper, aluminum and other materials into a flat wire, and Air Europe presses the flat wire machine in a square, semi-circular shape, etc. The wire roller is made of high-quality chrome steel or tungsten steel.

The flattening machine of the steel processing equipment can effectively use its special processing when it is manufactured. When it is used, the service life is long and the surface of the rolled wire is smooth and the dimensions are accurate. No cooling lubrication is required during the use of the flat yarn machine. If lubrication is really needed, the lubricant must be used when starting work to avoid cracking and scrapping of the carbide roll after it is heated and quenched.

The steel processing equipment compactor shall shut down the power for a long time to stop, lift the roll or roll out all the wire, so as to avoid the eccentricity of the work surface caused by the long-term one-way force affecting the rolling uniformity. The use of a four-band single-gear shift gearbox not only facilitates speed adjustment, but also reduces the load on the motor and extends the life of the motor.

There are many types of steel processing equipment, among which the flattening machine is also one of many devices. In the process of operation, there are all sorts of components such as a cutting table with a cutter and a flattener. In the process of use, according to the form of the cutter, it can be effectively divided into a rotary type and a reciprocating type to a certain extent. There are three kinds of types of headers including a screw-push type, a conveyor type and a non-transport device. On some large-scale self-propelled mower conditioners, spiral propeller headers or conveyor belt headers can be used.

In the process of operation, the cam-controlled reed-type reeling wheel is generally used in the operation. In the course of the operation, the reeling wheel rotates the pasture to the cutter. The cut steel is sent to the flattener by an auger.

After the flattened pasture is thrown backwards, the steel is integrated on the ground behind the implement through the bulking board and the gathering board. The flattener is usually a pair of steel rollers or rubber rollers with grooves on the surface and has a diameter of about 200 mm and is driven by the power to rotate relative to each other. The pasture is crushed when passing through the gap in the two rollers. This type of compactor has a strong conveying capacity and is suitable for harvesting high yield pastures.

http://www.alucncmachining.com/