Product Categories
Customer Service
Contact: Cora, 86-139 52463646
Email: cora07@sina.com
Skype: corelincai
When processing assembly line parts, we need to pay attention to the operation and maintenance of the assembly line processing equipment in order to ensure the quality of the line parts processing. First of all, it is about electrical operation briefly. The power supply on the assembly line processing equipment needs three-phase four-wire, the outside should be equipped with a total switch, (three-phase four-wire four-pole switch can be used, the switch can only control the three-phase power supply, the zero line is direct, and attention can not be put second The zero line of the method also passes another switch).
For the maintenance of assembly line processing equipment, the maintenance of the head motor and the specific methods for its maintenance must pay attention to not allowing the motor to feed water, nor to add diesel oil and liquid organic compounds to the motor. This will also lead to motor The insulation is damaged and fails. The maintenance method of the speed head is the same as the motor.
The maintenance and repair of chains on assembly line processing equipment means that after the long-term operation of the chain, it will inevitably cause the original lubricant oil to evaporate and volatilize. Afterwards, it will lead to unbalanced, noise-increasing or crawling of the chain during operation. Wait. At this time, it is also possible to open the closure plate at the tail end and add butter or thick oil to the chain.
The specific method of repair and maintenance of the head gearbox in the assembly line processing equipment requires that the oil used in the gear box must be put on the net for the first time in about three months, and the gear box should be cleaned with diesel or gasoline. After putting the net, add new lubricant to the middle of the observation window. (Each month should pay attention to whether the lubrication is too little).
During the repair and maintenance of the head gearbox in the assembly line processing equipment, it is necessary to take care that too much lubricating oil will inevitably lead to the heat generation of the gearbox. Excessive motor load will also cause the motor protection switch to trip. Too little lubricating oil may also cause the gear box to generate heat, the noise increases and the gear box is hanged and scrapped. such,The lubrication in the assembly line processing equipment must be appropriate, so as to extend the service life of the equipment and ensure the quality of the accessories.
http://www.alucncmachining.com/
Previous: Aluminum Processing Quality Inspection Basic Content
Next: Accuracy Guarantee Of CNC Machined Rail Parts Equipment
Related News
- What Is CNC Metal Processing Machinery
- CNC Hardware Processing Machinery P...
- Precision Metal Parts Sample Proces...
- What Are The Classifications Of Ind...
- Development And Finishing Of Indust...
- How To Treat After Oxidation Of Alu...
- Surface Anti-oxidation Treatment Of...
- How To Get The Corrosion Resistance...
- Five Most Common Surface Treatment ...
- What Is The Effect Of Black Electro...
- Aluminum Processing Quality Inspect...
- Car Radiator Processing Requirement...
- What Functions Should A Good Steel ...
- Square Steel Tube Processing Equipm...
- Analysis On Development Characteris...
- Double-head CNC Machining Center Me...
- International Economic: Germany Is ...
- Growth May Turn A Corner In The Sec...